How each is built
Spiral wound: a V-shaped metal strip wound together with graphite, PTFE or another filler, usually with an outer centering ring and often an inner ring. The winding acts as a spring.
Kammprofile (camprofile, grooved gasket): a solid metal core with concentric grooves machined on both faces, covered with a thin layer of graphite or PTFE. The facing flows into the flange finish while the core carries the load.
Side by side
| Property | Spiral wound | Kammprofile |
|---|---|---|
| Sealing element | Wound strip + filler | Grooved solid core + soft facing |
| Seating stress needed | Medium | Low |
| Thermal cycling | Very good | Very good |
| Blow-out resistance | Good | Very good (solid core) |
| Narrow or uneven flange faces | Needs good finish and width | Very good |
| Handling in large diameters | Can spring apart if mishandled | Rigid, easy to handle |
| Reuse | No | Core can be re-faced |
| Main standard | ASME B16.20 | ASME B16.20 (grooved metal), EN 1514-6 |
| Relative cost | Lower | Higher |
| Typical home | Pipe flanges, class 150–2500 | Heat exchangers, problem joints |
General guidance only; the final choice depends on your flange, bolt load and service.
Choose spiral wound when
- it is a standard ASME B16.5 or B16.47 pipe flange;
- the piping specification calls for it, as most do;
- cost and ready availability by size and class matter.
See JaySeal spiral wound gaskets and CG vs CGI.
Choose kammprofile when
- it is a heat exchanger joint, especially with pass partitions or narrow seating width;
- bolt load is limited, or the flange is light;
- a jacketed or spiral wound gasket has leaked in that joint;
- the gasket is large and must survive handling, or you want to re-face and reuse the core.
See JaySeal kammprofile gaskets and heat exchanger gaskets.




